[SG-112R]

40W(RMS), DUAL CHANNEL-CLEAN/OVER DRIVE

3 BAND EQUALIZER

EFFECT LOOP-(SEND/RETURN),CD/TAPE INPUT WITH VOLUME

12" CELETION SPEAKER

HEAD PHONE,FOOT SWITCH JACK

COOL BLUE LIGHT ILLUMINATION PANEL

H,390mm x D,230mm x W,550mm

 

 

 

INPUT

 Connect your guitar here using a shielded instrument cable

CLEAN

VOLUME

 This control sets the output volume level from the clean channel:

CHANNEL S/W

 Channel select switch "Clean or OVER DRIVE" (LED ON)

OVERDRIVE

 

 

GAIN

 This control sets the amount of compression and distortion from the amplifier.  With the control towards for left, the sound will have a thick compressed quality.  As you turn the control to right the amount of distortion increases.

 

LEVEL

 This conrol sets the output volume from the overdrive channel:

 the far-left position there will be no output; as you turn the control to the right the  output increases.

EQUALIZATION

 

 

TREBLE

 Adjust the high frequency output level with control:(+- 16dB at 5kHz)

 

MIDDLE

 Adjust the mid frequency output level with this control:(+-12dB at 1kHz)

 

BASS

 Adjust the low frequency output level with this control:(+-10dB at 100kHz)

REVERB

 

 

LEVEL

 Adjust the amount of spring reverb effect with this control:

AUX

 

 

VOLUME

 This controls for "CD/AUX" Input level(connecting CD players or tape decks)

 

CD/AUX

 This RCA jack for connecting CD or Tape deck and etc..

HEADPHONE

 Fo private practice sessions, plug a pair of stereo headphone into this jack.

POWER

 This heavy-duty rocker switch is used to turn the amplifier ON in the up position,  (control panel will illumination as cool blue)

EFFECT LOOP

 

 

SEND

 Use this jack to feed the signal to the input of on FX processor (effector)

 

RETURN

 Line out signal to an FX processor (effector)

LINE OUT

 This output for the second power amp or through to a mixing console.

FOOT SWITCH

 This jack is for footswitch to switch back and forth bewteen the CLEAN and DRIVE  channels

SPECIFICATIONS

 Output power Rating ----- 35W watts RMS @5% THD 8 ohm

 Preamp section        ----- -12 dBV/1M ohm

                                      -6 dB 30k ohms

Frequency response   ----- 20Hz ~ 30kHz(into 8 ohms)

Speaker                   ----- 12" custom Designed "celestion specker

Power Requirements  ----- 230v 60Hz 70 watts max (Fuse: T500mA 250v)

Size and Weight        ----- 225mm(D)x417mm(W)x473mm(H), 12kg